I had to figure out a way to hold the @JustSpices containers in the same spot for each picture without being complex or visible in the pictures. I also had to anchor the camera so it didn’t move throughout the process.
The containers have a plastic top and bottom. Both have a cavity. I couldn’t use the top to anchor the container without it being visible. I would need to put something under them. It needed to hold each in place but at the same time allow the containers to be switched easily.
I decided that a disc, slightly smaller than the inside diameter of the cavity would be the best solution. Each container would end up in the same relative spot in relation to the camera and the backdrop. It would also allow the containers to be switched out easily. Using a small piece of modeling clay would keep the disk in place but not have the potential to damage my backdrop.
I used some modeling clay to anchor the camera stand and to make sure the camera didn’t move I used my watch to trigger the shutter.
After everything was set up I took all of the photos that I would need. The amount of time it required was much shorter than previously. I would like to think the ease was at least in part a result of my planning but can’t swear to it.
I did not have time today to research making a short video in Final Cut Pro to see if there was an easier way to string the pictures together and sync the soundtrack to such a short video.
That’s all for tonight. I hope that you all are well.
My Final Cut Pro 